Update Prop Pic

Brass Water Valve

Part made for someone who had a faucet from the 80s that is no longer available.

Threading Plastic Stud

TV mount

Shaped and Anodized

Rotery Table Mounted on Lathe

Test Table

Helical Gear for Paper Shreader

I cut this gear to replace the plastic one in my paper shredder. Also a test to see if I could make a tooth cutter out of a router bit and make a helical gear. worked!

Chuck Spacer Blocks

These are used to mount items like car break rotors. They provide a larger suffice area providing a more true cut.

Chuck Spacer Blocks in Use

These allow me to get mounter objects more stable and true.

Half Round Cut in L Bracket

Needed two of these for my tool sharpener setup I was building.

Break Roter Refinishing

Refinished Roter

When the are no longer good for the car. They are a good source of metal for some projects.

Slider Door Panel Locks

For a door made in the 80s that needed repair. New pieces have increased thickness, surface area, and an additional mounting hole.

Making of Slider Door Panel Locks

Cutting Slot

Making of Slider Door Panel Locks

Surfice Grinding

Cam Shaft Test

Testing out new medium sized 4 jaw chuck.

Electronics Center Work Tables

Made from left over oak flooring. to become my work bench for electronics.

Scrap Metal To Become a Clamp

Using the band saw to cut this scrap metal.

Clamp In the Making

Used portable band saw to cut notches out.

Clamp for Large Vice.

Because the large vice sits between two slots. I made this clamp to straddle between two slots to clamp the center of the vice.

Round Grover

O-Ring Seated After Groving

This mode was for someone who had a camera slider

Modded Camera Mount finished

O-Ring was grooved in so when plates were locked together, they would not slip when torque was applied.

IMG-20130810-01738

Glass Tube Cutting